Mornsun LM25-23B03 AC/DC 25W Enclosed SMPS

Description

Mornsun LM25-23B03 AC/DC 25W Enclosed SMPS

The LM25-23B03 is an enclosed type AC/DC power supply from Mornsun. It has an output voltage of 3.3V and a maximum output current of 6A, for a total power output of 19.8W. The input voltage range is 85-305VAC, and the output voltage is adjustable in 10mV steps. The power supply is also equipped with a power factor correction (PFC) function, which helps to improve the efficiency of the power supply and reduce the amount of power wasted as heat.

The LM25-23B03 is a versatile power supply that can be used in a variety of applications, including industrial automation, telecommunications, and consumer electronics. It is also compliant with a number of safety standards, including IEC/EN 62368-1 and UL 62368-1.

Features:

• Enclosed type
• Output voltage: 3.3V
• Output current: 6A
• Power output: 19.8W
• Input voltage range: 85-305VAC
• Adjustable output voltage
• Power factor correction (PFC)
• Compliant with IEC/EN 62368-1 and UL 62368-1

check out :Mornsun LM25-23B48 AC/DC 25W Enclosed Switching Power Supply

Note:

• Unless otherwise specified, parameters in this datasheet were measured under the conditions of Ta=25?, humidity<75%RH with nominal input voltage and rated output load
• The room temperature derating of 5?/1000m is needed for operating altitude greater than 2000m
• All index testing methods in this datasheet are based on our company’s corporate standards
• In order to improve the efficiency at high input voltage, there will be audible noise generated, but it does not affect product performance and reliability
• The out case needs to be connected to the earth ( )of system when the terminal equipment in operating
• The output voltage can be adjusted by the ADJ, clockwise to increase
• Our products shall be classified according to ISO14001 and related environmental laws and regulations and shall be handled by qualified units
• The power supply is considered a component which will be installed into the final equipment. All EMC tests should be confirmed with the final equipment