X500 V2 Drone Kit with Pixhawk 6X with M10 GPS and 433MHz Telemetry

Description

Feature:

• All newPixhawk 6X Flight ControllerwithM10GPSModuleandPlug & playSiK Telemetry Radio
• New frame design with minimal assembly time (~30minutes), No soldering required
• Carbon Fiber frame with fiber-reinforced nylon connectors providing easy & straightforward installation
• Pre-installed motors & ESCs with simple XT30 power plugs for PDB
• Power distribution board (PDB) with XT60 & XT30 plugs
• Mount for companion computer such as Raspberry Pi & Nvidia Jetson Nano
• Optional depth camera mount for Intel RealSense & Structure Core

Note:

• The Pixhawk 6X version now ships withPM02D-HV(High Voltage) version.In PX4, you must setSENS_EN_INA228to enable this.This HV version is only supported in ardupilot 4.4 & later. Setup Guide can be foundhere.

• Firmware Support for M10 GPS:PX4 1.14 and ArduPilot 4.3 or newer is required.

PX4 Development Kit – X500 v2 Includes:

• Autopilot Flight controller:Pixhawk 6X (Standard Base)&PM02D
• M10 GPSModule
• SiK Telemetry Radio V3 433/915MHz
• X500 V2 Frame Kit(SKU30120)
• Preinstalled Items:
  • Motors – Holybro 2216 KV920Motor (4 pcs) with XT30 Plug
  • ESCs- BLHeli S ESC 20A (4 pcs) with XT30 Plugs – Compatible with 4S Battery
• 1045 Propellers (6 pcs)
• Power Distribution Board(XT60 plug for battery & XT30 plug for ESCs & peripherals)
• Other Optional Items(Sold Seperately)
  • RadioMaster TX16S RC Controller
  • RadioMaster R81 Receiver
  • Depth Camera Mount

X500 V2 Frame Kit Details (SKU30120):

• Body – Full Carbon Fiber Top & Bottom plate (144 x 144mm, 2mm thick)
• Arm – High strength & ultra-lightweight 16mm carbon fiber tubes withnewly designed fiber reinforced nylon connectors
• Landing gear -16mm & 10mm diameter carbon fiber tubes with strengthened & improved plastic tee connectors.
• Platform board – With mounting holes for GPS & popular companion computer such as the Raspberry Pi 4 & Jetson Nano
• Dual 10mm rod x 250 mm long rail mounting system
• Battery mount with two Battery Straps
• Hand tools for installation

Mechanical Specification:

• Wheelbase: 500mm
• Motor mount pattern: 16x16mm
• Frame Body: 144x144mm, 2mm thick
• Landing gear height: 215mm
• Space between top and bottom plates: 28mm
• Weight: 610g
• Flight time: ~18 minutes hover with no additional payload. Tested with 5000mAh Battery.
• Payload: 1500g (without Battery, 70% Throttle)
• Battery Recommendation: 4S 3000-5000mAh 20C+ with XT60 Lipo Battery (Not Included)