Sale!
iFlight GM5208-12 Encoder Combo Set for Brushless 3-Axis Gimbal Stabilizer (AS5048A, Alexmos 32BIT)

iFlight GM5208-12 Encoder Combo Set for Brushless 3-Axis Gimbal Stabilizer (AS5048A, Alexmos 32BIT)

Original price was: $553.83.Current price is: $148.00.

SKU: BVHB1865359711 Category:

Description

Overview

The iFlight GM5208-12 Encoder Combo Set adds encoders to each brushless gimbal motor so the gimbal control system can track motor position more accurately for improved stabilization and better power efficiency. In a 3-axis stabilization gimbal, passive inertial stabilization requires careful camera balance on the pan/tilt/roll axes, while active stabilization uses sensors to measure motion and counteract it using motors on each axisencoders support this active control by improving position feedback.

Key Features

  • Easier gimbal tuning with reduced calibration work.
  • Power saving; stated up to 5 times longer working time than gimbals without an encoder system.
  • Twin IMUs.
  • Faster response; stated instant torque increase and improved behavior at difficult rotation angles.
  • Encoder chip: AS5048A.

For compatibility questions (gimbal controller, wiring, and setup), contact https://rcdrone.top/ or [email protected].

Specifications

Model GM5208
Motor Out Diameter 630.05mm
Configuration 12N/14P
Motor Height 30.70.2mm (included with encoder housing)
Hollow Shaft (OD) 15-0.008/-0.012 mm
Hollow Shaft (ID) 12+0.05/0 mm
Wire Length 6103mm
Cable AWG #24
Motor Weight 2090.5g
Wire plug 2.5mm dupont connector
No-load current 0.090.1 A
No-load volts 20V
No-load RPM 456~504 RPM
Load current 1A
Load volts 20V
Load torque (g) 1800-2500
Motor internal resistance 15.25% (resistance varies with temperature)
High voltage test DC500V 10mA @ 1sec
Rotor housing runout 0.1mm
Steering (axle extension) clockwise
High-low temperature test (high) Keep at 60C for 100 hours; motor can work normally after 24 hours at room temperature
High-low temperature test (low) Keep at -20C for 100 hours; motor can work normally after 24 hours at room temperature
Maximum power 40W
Working Voltage 3-5S
Working temperature -20 to 60C; 10 to 90% RH

What’s Included

  • 3 x GM5208-12 gimbal motor with AS5048A encoder & magnet
  • 1 x Alexmos 32BIT BGC board (encoder version, without aluminum case)
  • 1 x connecting cables set

Applications

  • 3-axis brushless camera gimbal stabilization systems requiring encoder feedback
  • Gimbal upgrades where improved position tracking and tuning efficiency are required

Reviews

There are no reviews yet.

Be the first to review “iFlight GM5208-12 Encoder Combo Set for Brushless 3-Axis Gimbal Stabilizer (AS5048A, Alexmos 32BIT)”

Related products